Instructions for an Ikea Malm Bed
The Ikea Malm bedroom series blends sleek, modern lines with functionality, and the Malm bed is no exception, with several finish choices and optional under-bed drawer storage.
Ikea's wordless directions have been confusing customers since the 1960s.
But, despite its versatility and simple appearance, the graphics-only instructions provided with the bed can push even the most advanced DIY expert to frustration. Combine written instructions with the pictures provided by Ikea for faster, easier assembly.
Things You Will Need
- Phillips-head screwdriver
- Drill with Phillips-head bit (optional)
- Lay the headboard and foot board flat on the floor with the pre-drilled holes facing up and the holes along the edges facing each other. Gather the four threaded studs and insert two into the middle holes on the left and right sides of the headboard. Tighten them with the provided wrench. Insert the remaining two into the middle holes on the foot board, tightening them with the wrench.
- Locate the predrilled holes along the edges of the headboard and foot board. Push the two-prong, flat back pieces into the slots, three in the headboard and three in the foot board.
Tip
Your bed should come with a wrench for assembly. If you misplace it, any small, adjustable wrench will do. The drawers, if purchased, assemble easily. Lock the rails into the drawer face with dowel rods and cam bolts, and secure the drawer back to the rails in the same manner. Screw the base into place and then add the wheels.
Warning
Check all of the pieces thoroughly before you begin to ensure you have everything you need, and nothing is broken.
The Drip Cap
- The Ikea Malm bedroom series blends sleek, modern lines with functionality, and the Malm bed is no exception, with several finish choices and optional under-bed drawer storage.
- Tighten them with the provided wrench.
- Push the dowel rods into the ends of the two side rails, three per end.
- Position the angled support rail bracket on the interior face of the headboard near the bottom, lining up the brackets holes with the pre-drilled holes on the headboard.
- Secure it with two screws, and then install the second bracket in the same manner on the foot board.
- Repeat this step at the foot board.
